OBi200 power LED flashing red and green
DocHudson:
All our devices are on a timer. They turn off at night and start in the morning.
Just now noticed that OBi 200 power LED is blinking red and green. I power cycled the device but it didn't change anything.
A quick google search leads me to https://www.obitalk.com/info/faq/Troubleshooting-sec/power-light-meanings It says, the power went out while the firmware update. The link to the troubleshooting guide goes to 404.
I found an alternative link https://www.obitalk.com/info/support/troubleshooting but I am unable to find a link to the firmware.
Does anyone have a link for the firmware?
Thanks in advance.
Thanks in advance
drgeoff:
It's in an appropriately titled sticky thread in this very section of the forum.
(When you have your OBi sorted out, perhaps a visit to your optician would be in order!)
DocHudson:
Thank you for your reply.
I actually did notice the sticky but the firmware listed in the thread is from 2019. When I did a bit of googling to understand the flashing light, I read that power loss during firmware upgrade would be a cause. So I assumed that there is a newer version.
Sheffield_Steve:
Why are you removing power from all your "devices" every night? That's really asking for trouble.
Taoman:
Quote from: DocHudson on October 24, 2020, 05:09:36 am
Does anyone have a link for the firmware?
Link for latest firmware is in the following post:
http://www.obitalk.com/forum/index.php?topic=16008.msg99561#msg99561
Navigation
[0] Message Index
[#] Next page