I have a SIP provider with an administration portal I can use to add numbers to my inventory with them, and then route them to a destination. I added two numbers to the inventory, and pointed them to the public IP address where my Obi302 resides. I put server information for the provider in the ITSP-A configuration.
I configured voice services SP1 and SP2, one for each of the numbers. The authentication credentials are stored in those voice service configurations. When the device boots up, it makes two registrations with the provider. I continued with some other configuration work and got it to this point:
A call made from phone port one to my cellphone completes on my cell, and caller ID shown is correct (i.e. for the first of my two numbers). A call made from phone port two completes just the same, but shows the caller ID of the second of my two numbers. So, outbound calls work as hoped.
I want inbound calls to be routed according to which number was dialed. If somebody calls the first of my numbers, I want phone port one to ring. If somebody call the second of my numbers, I want phone port to to ring. My intent is for these two lines to be completely unrelated to each other other than they are sourced by the same SIP provider, and terminated on the same Obi302.
I simply cannot manage to get this to happen. Any calls to either of my numbers cause phone port one to ring. Where and how do I tweak the configuration of this Obi302 to make the inbound call routing that I seek actually happen?
BTW, I'm not using the Obitalk website where you can enroll multiple devices for configuration. I'm doing all my work by simply logging into the Obi 302's web interface and configuring everything directly. That's the way I want to do it.
Thanks in advance for any pointers.