OBi1000e Sidecar w/ OBI1062 - Not Found
drgeoff:
Quote from: vsc1062 on February 09, 2021, 11:55:46 am
I received a response from Poly this morning asking for the OBI number of the 1062. I responded and then they told me to look in expert. That said I had removed the sidecar, but reattached it. It immediately was functional. But I reconnected it no different than several prior attempts.
Did they push something to the phone? Unknown but it is shown as connected and the buttons work.
That said I believe a limitation is that a pause cannot be programmed say for a conference call (e.g. phone number, pause, participant code).
I have a vague memory that perhaps it can. But it is more than a pause. The phone number digits are sent as a data packet to your ITSP. They use that to route the call. When the call is answered by the conferencing system it expects DTMF digits (aka "Touch Tone") so the OBi has to change the way the digits are handled.
My vague memory is that one of the firmware upgrades for the OBi ATAs added that feature. I would expect that would have been carried into the OBiphones. I'll try to find the forum thread about it.
drgeoff:
My memory was not just vague but muddled too. See http://www.obitalk.com/forum/index.php?topic=10342.0, especially the final post by ianobi.
Navigation
[0] Message Index
[*] Previous page