Unable to call on Broadvoice using SP2
Obitalk:
Thank you for the suggestion Obi Guru.
I also went through the OBI configurations for SP1 and I think these are the setting/fields that are filled up by the config wizard for Broadvoice. I'm enclosing this so that if someone else wants to manually configure either SP1 or SP2 for Broadvoice, they can manually do it.
ITSP Profile A --> General
DigitMap : Default unchecked ((1xxxxxxxxxx|<1YYY>[2-9]xxxxxx|011xx.|xx.) (Replace YYY with the your phone number AREA Code)
ITSP Profile A --> SIP
ProxyServer : sip.broadvoice.com (Default unchecked)
ProxyServerPort : 5060 (Defualt unchecked)
OutboundProxy : leave the value blank (Default unchecked)
OutboundProxyPort : 5060 (Default unchecked)
Voice Services --> SP1 Service
X_ServProvProfile : A (Default unchecked)
X_RingProfile : A (Default unchecked)
X_CodecProfile : A (Default unchecked)
X_RegisterEnabe : Selected (Default unchecked)
Voice Services --> SP1 Service --> SIP Credentials
AuthUserName : BV Phone Number
AuthPassword : BV authorization password
Obitalk:
If anyone is using Broadvoice multipresense, I was able to successfully configure it using the device configuration wizard on the ObiTalk portal.
I selected the Generic Service Provider and populated the URI field in the following format:
phonenumberx11@sip.broadvoice.com
Exmaple : The URI field containes 3307702400x11@sip.broadvoice.com
Obitalk:
I might have stated this incorrectly. I don't think the Broadvoice Multipresence is working by using the URI field. Please disregard the previous post. Thanks
Obitalk:
I had to perform a SIP debug and it indictaed that there was a CONFLICT. I had to tweak the URI a little and add user=phone and it seems to get registered now.
Navigation
[0] Message Index
[*] Previous page