Cannot make Obi-to-Obi calls on Obi2182s
FlintstoneGummy:
Weird. The Obitalk button just turned orange for a few seconds, and could receive, but not make calls from the other phone. Now it stopped working again.
SteveInWA:
Are you using the OBiTALK device configuration portal? If you are making changes on the local web UI, then, unless you have purposefully disabled using it on your two phones, then whenever the phones are power-cycled or rebooted, the portal will overwrite the local changes.
FlintstoneGummy:
Always the portal. Too afraid to use the Expert Mode.
SteveInWA:
Go ahead and use Expert Mode.
The line key configuration settings via the portal for the OBi 2000 series are a mess, and the only reliable way to do it is via Expert mode.
Look carefully at my screenshot. Note that you must first un-check both boxes to the right of a parameter's value to enable editing. After you edit the values, scroll down to the bottom of the page and submit, and wait at least 5 minutes.
drgeoff:
Granted I have not tested with an OBi2182 but I have done the test with an OBi1032 and it is not necessary to have a LINE key assigned to the Obitalk service to make or receive **9 type calls.
Certainly an OBi2182 can make **9 type calls without such a LINE key as the OP has already proved by successfully calling the echo test number.
Therefore I strongly suspect that the problem lies elsewhere and that assigning a LINE key to the Obitalk Service will not bring a solution. (Conversely, successfully configuring such a key will not make the problem any worse.)
Is there anything unusual about the OP's network, such as a firewall over and above that found in a typical home router?
Navigation
[0] Message Index
[#] Next page
[*] Previous page