Hook up POTS to Obi2182 via Obi212?
myobinameisinuse9987:
After adding Voice Services / ObiTalk Service / InboundCallRoute :
{tttwwwvvv>(xx.):li}
Same result, Call failed 404 Not Found (or something similar)
tttwwwvvv is Obi number of 2182, no spaces.
Call History of 2182:
From PH1 To PP1(8*+1aaabbbcccc)
Still nothing in Call History of 212
I'm guessing this means 2182 isn't actually SENDING the call to 212, so probably my DigitMap or Outbound route?
drgeoff:
You are really not getting it!
If you change the 1 to an 8 in the DigitMap you need to do the same in the OutboundCallRoute. As azrobert explained that 1 is being changed to the 9 digit number of the 212. That's what <x:y> syntax is all about.
Go and slowly read pages 191 to 203 of the OBi Device Admin Guide. (Yes it is is for the ATAs but the OBiPhones follow the same rules.) Then read it again. And once more for good measure. By then you should understand most of it and know which specific bits to refer to when things are not happening as you expect.
azrobert:
If you want to use 8 as the prefix then you must change the outbound route:
{<8:123456789>*(@@.):pp}
I also dont understand why the + prefix.
Use this OBi212 OBiTalk inbound route to remove the +:
OBi212 OBiTalk inbound route:
{111111111>(<+:>xx.|xx.):li}
myobinameisinuse9987:
Something has changed. This is what I have in 2182:
123456789 is obi number of 212
987654321 is obi number of 2182
2182 IP Phone / PHONE Settings / DigitMap :
(8*xx.S4|[1-9]x?*(Mpli))
2182 IP Phone / PHONE Settings / OutboundCallRoute :
{<8:123456789>*(@@.):pp}
212 Voice Service / ObiTALK Service / DigitMap :
(<ob>xxxxxxxxx|obxxxxxxxxx)
212 Voice Service / ObiTALK Service / InboundCallRoute :
{987654321>(<+:>xx.|xx.):li}
Result is a Voice: There is no call route available to complete your call
Still nothing in the Call History on 212
Now no new items in call history for 2182
I have read the OBIAdmin Guide section over and over. Still no solution.
Do I have the DigitMap and Call routes on the right devices and under the correct setting?
myobinameisinuse9987:
If I didn't want to use any speeddial or maps, etc, what would be the RAW dialing on the 2182 to manually send a call over the 212?
Or better yet, how do I get a dialtone from the line of the 212, using the 2182?
Navigation
[0] Message Index
[#] Next page
[*] Previous page