Detailed Guide to Configure Obi2162 to dial out using PSTN line on OBi212

<< < (4/6) > >>

RodgerDJr:
Yes I do ;D. I guess there is a better way.

I have one of my right keys as OBITalk which seems to be my Xfinity number.  I can just press that when I want to dial out on that line.  

RodgerDJr:
OK I am able to dial out on my 2182 using the landline on the 212, but I am not receiving calls on the 2182. 

I did make this change on the 212

Physical Interfaces >> LINE Port >> InboundCallRoute
     {ph}, {pp(680######)}

Voice Services >> OBiTALK Service >> InboundCallRoute
     {680######>(xx.):li}

680###### This is my OBINumber for the 2182

I made This change on the 2182

Voice Service >> OBITALK Service >> DigitMap
     (xxxxxxxxx|<520######*>(xxxxxxx|xxxxxxxxxx|1xxxxxxxxxx)|xx.*xx.)
Do I need the * after my OBiNumber?

520######  This is my OBINumber for the 212


Thank you again.

azrobert:
Quote from: azrobert on September 11, 2021, 09:06:27 am

OBi212
Physical Interfaces -> Line Port -> InboundCallRoute:
ph,pp(2182)

Replace 2182 with the OBi number of the OBi2182

OBi2182
Voice Services -> OBiTalk Service -> InboundCallRoute: ph



You didn't follow my instructions. You have:
  {ph}, {pp(680######)}
This has 2 rules. The  1st is unconditional, so the call is always sent to ph and ignores the second rule.
Rules are within {}

I have one rule, so the call is sent to both.
If only one rule, the {} is not required.

Edit:
The OBiTalk inbound route is the default. I included it because it might get automatically changed when you have more than 1 OBi device.

RodgerDJr:
Sorry about that.

OK I am following what you have, I thought I had it how you have it but looking I see I was wrong. 

OBi212
Physical Interfaces -> Line Port -> InboundCallRoute:
ph,pp(680######)

OBi2182
Voice Services -> OBiTalk Service -> InboundCallRoute:
ph


I have attached screenshots of my settings, maybe I have something else wrong. 

When I call my landline the POT rings that is connected to the 212 but the 2182 does nothing.  I am able to make calls from the 2182 using the landline, by selecting the line I have designated for OBITalk or by dialing **9 and then the number I want to dial. 

Again I thank you for all your help.

azrobert:
It looks like you are displaying the setting directly from the OBi212 and OBi2182. Did you make the changes from OBiTalk or directly from the devices? If you made them directly on the devices, OBiTalk will overlay the changes and they will revert back to the previous settings.

Please dial **9620nnnnnn from the phone attached to the OBi212. Does the OBI2182 ring?

Look at the call history of the OBi212.
Does it show the call being routed to OBiTalk?

Log directly on the device.
Status -> Call History

Navigation

[0] Message Index

[#] Next page

[*] Previous page