Can't add device and other problems
RonR:
That's weird. Resetting the OBi to factory defaults ought to clear anything in progress. I'm at a loss for suggestions. Maybe you received a defective OBi.
boke:
It may be defective, I'll try a little more then contact OBiHAI. Thanks for trying to help.
I just reflashed the firmware again. Still the same results..
Stewart:
What does the Phone and Line port status show? If either is shown as off hook, disconnect your phone (and phone line, if applicable) from the OBi and check again. If still off hook, IMO the device is defective.
boke:
It shows "On Hook".
The power light is flashing green. According to the support docs this means its looking for an ip address. But it has one, it's 192.168.1.118 and i can connect to the web interface without problem.
I just can't make any changes to anything other than the 'Network Settings' page. Anything else and I get the device is busy message.
boke:
Below is a syslog from my OBi100
Two of the logs in particular look bad. Looks like I am a victim of a bad flash. But shouldn't reflashing fix this?
Code:
Thu 11/3/2011 11:28:11 AM: 192.168.1.118 >>Kernel.Debug<<<7> PROMPT:UsrBankChksumErr
Thu 11/3/2011 11:28:11 AM: 192.168.1.118 >>Kernel.Debug<<<7> ++++ user prompt corrupted
Entire syslog:
Code:
Thu 11/3/2011 11:28:06 AM: 192.168.1.118 >>Kernel.Info<<<6> ==== Networking is ready ====
Thu 11/3/2011 11:28:06 AM: 192.168.1.118 >>Kernel.Emergency<<<0> IP Address= 192.168.1.118
Thu 11/3/2011 11:28:06 AM: 192.168.1.118 >>Kernel.Emergency<<<0> Gateway = 192.168.1.1
Thu 11/3/2011 11:28:06 AM: 192.168.1.118 >>Kernel.Emergency<<<0> Netmask = 255.255.255.0
Thu 11/3/2011 11:28:06 AM: 192.168.1.118 >>Local.Notice<<<173> ZT: CustomID 0
Thu 11/3/2011 11:28:06 AM: 192.168.1.118 >>Local.Notice<<<173> ZT: Prepare to contact server
Thu 11/3/2011 11:28:06 AM: 192.168.1.118 >>Kernel.Emergency<<<0> SLIC_init ...
Thu 11/3/2011 11:28:06 AM: 192.168.1.118 >>Kernel.Emergency<<<0> Reset SLIC...
Thu 11/3/2011 11:28:06 AM: 192.168.1.118 >>Local.Info<<<150> Setup Provisioning for system start! 1600
Thu 11/3/2011 11:28:07 AM: 192.168.1.118 >>Kernel.Emergency<<<0> SLIC & DAA is initialized
Thu 11/3/2011 11:28:09 AM: 192.168.1.118 >>Kernel.Info<<<6> Start Main Service Now
Thu 11/3/2011 11:28:09 AM: 192.168.1.118 >>Kernel.Debug<<<7> Voice Main
Thu 11/3/2011 11:28:09 AM: 192.168.1.118 >>Kernel.Debug<<<7> [CPT] --- FXS s/w tone generator (ringback) ---
Thu 11/3/2011 11:28:10 AM: 192.168.1.118 >>Kernel.Debug<<<7> BASESSL:load cert:5
Thu 11/3/2011 11:28:10 AM: 192.168.1.118 >>Kernel.Debug<<<7> BASESSL:Load certificate ok
Thu 11/3/2011 11:28:10 AM: 192.168.1.118 >>Kernel.Debug<<<7> XMPP:Invalid cfg use for xmpp
Thu 11/3/2011 11:28:10 AM: 192.168.1.118 >>Kernel.Debug<<<7> GTT:xmpp not configured
Thu 11/3/2011 11:28:10 AM: 192.168.1.118 >>Kernel.Debug<<<7> XMPP:Invalid cfg use for xmpp
Thu 11/3/2011 11:28:10 AM: 192.168.1.118 >>Kernel.Debug<<<7> GTT:xmpp not configured
Thu 11/3/2011 11:28:11 AM: 192.168.1.118 >>Kernel.Debug<<<7> PROMPT:UsrBankChksumErr
Thu 11/3/2011 11:28:11 AM: 192.168.1.118 >>Kernel.Debug<<<7> ++++ user prompt corrupted
Thu 11/3/2011 11:28:11 AM: 192.168.1.118 >>Kernel.Debug<<<7> [SLIC]:Slic#0 ON HOOK
Thu 11/3/2011 11:28:11 AM: 192.168.1.118 >>Kernel.Debug<<<7> +++++ Onhook while onhook
Thu 11/3/2011 11:28:17 AM: 192.168.1.118 >>Kernel.Debug<<<7> [CPT] --- FXS s/w tone generator (sit_1) ---
Thu 11/3/2011 11:28:22 AM: 192.168.1.118 >>Local.Info<<<150> PROV: Start to download files ...
Thu 11/3/2011 11:28:22 AM: 192.168.1.118 >>Local.Error<<<147> PROV: Invalid server name, Skipped
Thu 11/3/2011 11:28:22 AM: 192.168.1.118 >>Kernel.Debug<<<7> [CPT] tone compression done - 12523 !!
Thu 11/3/2011 11:28:36 AM: 192.168.1.118 >>Local.Notice<<<173> Contacting Server ...
Thu 11/3/2011 11:28:36 AM: 192.168.1.118 >>Kernel.Debug<<<7> TCP:Connect OK(HTTP GET)15
Thu 11/3/2011 11:28:36 AM: 192.168.1.118 >>Kernel.Debug<<<7> Trying to connect ssl
Thu 11/3/2011 11:28:37 AM: 192.168.1.118 >>Kernel.Debug<<<7> TC:ssl connected
Thu 11/3/2011 11:28:40 AM: 192.168.1.118 >>Local.Info<<<158> HTTP response code: 404
Thu 11/3/2011 11:28:41 AM: 192.168.1.118 >>Local.Notice<<<173> ZT: Contacting Server failed!
Thu 11/3/2011 11:28:41 AM: 192.168.1.118 >>Local.Notice<<<173> ZT: Retry in 600 s
Thu 11/3/2011 11:30:30 AM: 192.168.1.118 >>Kernel.Debug<<<7> [PR] prompt transcoding done!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page