Telnyx and Obi2XX
AsterionOmega:
I'm using Telnyx and can get Obi2XX devices registered.
I set them up using TLS/SRTP:5061 or UDP/TCP:5060 on sip.telnyx.com and outbound calls work with 2-way audio.
My issue is that incoming calls get rejected with a 404 error from the Obi Adapter itself.
My tests included setting the adapter DMZ, and swapping between SRTP and UDP:5060 with no avail.
Telnyx has said this is an adapter issue (which the call logs support), which i'm inclined to agree with.
Anybody else get incoming call errors from non-port issues? If so, what is the fix here?
theancient:
Did you ever get this issue solved? I am with voip.ms and they have been dead for 6 days from DDoS attack. I have checked for alternatives and Telnyx looks like a good choice, cost wise. Thanks for any help.
KuBand12:
Same story here.
I'm using an OBI200 and have it set up with Telnyx. I have just gotten registered on their sip.telnyx.ca server and have tested inbound and outbound calls with no issues. I set telnyx up on SP3, GV on SP1, and I will keep voip.ms on SP2.
I am using TLS on my Zoiper android softphone, and UDP on the OBI200, but I will be converting that to TLS as well. Let me know if there is anything you need to get setup.
TheTrev:
I think it was due to the way I had inbound setup.
Using a guide for a similar ATA (Cisco) you can see there is a little setup to do for the Inbound to be a number Format DNIS as SIP User name... then it worked fine.
https://support.telnyx.com/en/articles/1130665-configuring-your-cisco-spa112-ata
for reference.
theancient:
Quote from: KuBand12 on September 22, 2021, 08:40:48 pm
Same story here.
Let me know if there is anything you need to get setup.
I don't know if it is my Obi200 box, or the fact that I don't know what I am doing, but I can not get 2 service providers to work. VOIP.MS is basically working for me again, but I would like to get Telnyx working as my outbound provider, since it is 40% cheaper. We can not afford a Smart Phone, so I use VOIP.ms as my Text Capability as well.
I added Telnyx as SP2, and set it as primary on both Obi talk and the Obi200 phone port. But, outgoing calls still used SPI unless I dialed **2 to select SP2 specifically.
When I set Telnyx on SP2 as the primary line, then all incoming calls on my VOIP.MS system would just get a busy signal.
So, how do I set up the OBI200 for both VOIP.MS as incoming calls (which lets me use it for Texting and call blocking), and then set Telnyx for the primary line for Outgoing calls. I tried setting the Primary Line as a Trunk Group with Sp2, Sp1 order, but that did not work for me, either.
Thanks for any suggestions. I have already tried the suggestion of the SIP Name on Telnyx.
Navigation
[0] Message Index
[#] Next page