Help Needed With OBi & Callcentric Use of SIPBroker **275

<< < (2/4) > >>

azrobert:
Can you define an outbound trunk on the PBX without registration?

Credentials:
Proxy: tollfree.alcazarnetworks.com
UserID: 10 digit number used for the outbound CallerID
Password: anything

LTN1:
Quote from: azrobert on June 27, 2021, 03:23:09 pm

Can you define an outbound trunk on the PBX without registration?

Credentials:
Proxy: tollfree.alcazarnetworks.com
UserID: 10 digit number used for the outbound CallerID
Password: anything



Thanks, azrobert, for the suggestion. I have a FortiVoice PBX system. I think the section for those UI configurations require an actual account registration with actual password. I'll upload some samples of my UI software. I don't think I can do those with my UI as the software requires an actual account to work. If I set up an actual alcazarnetworks.com account, I'm sure it would work. For example, with Callcentric, I have a registered account. Then I attach the SIPBroker **275 prefix when dialing toll-free numbers through Callcentric. I'll post some sample pictures of my UI.

azrobert:
See if the PBX will accept a blank Registrar Server. Maybe that will stop it from trying to register.

LTN1:
Quote from: azrobert on June 27, 2021, 11:20:47 pm

See if the PBX will accept a blank Registrar Server. Maybe that will stop it from trying to register.


Thanks, azrobert. Just tried that and the PBX's UI won't work properly with a blank registrar server. Attempted outbound calls just gets a busy signal.

These are not important issues for me...was just curious to know of possible workarounds to not being able to use **275 with my particular software.

azrobert:
If you only call a few 800 numbers, you can setup Phone Book speed dials in Callcentric

Speed Dial: *7501
Name: Cox
Number: 18002343993@tollfree.alcazarnetworks.com

Navigation

[0] Message Index

[#] Next page

[*] Previous page