Noticed 2 days ago, when I make changes to OBi202 and OBi212 configurations on
Obitalk.com, the new config is NOT pushed to the devices.
Previously, when new changes were made, the config was pushed to the device and the device rebooted.
I haven't tested with OBi1062 or OBi2182.
I had to log into the devices by IP address, make the changes locally, save, reboot. To be safe, I made the changes on BOTH
Obitalk.com and on the local devices.
I can confirm the telephone **x codes with xx# options worked to change IP Address and config options. This is what put me on the trail as I was troubleshooting IP address issue. (I had changed the address to static in
Obitalk.com before moving it to the new location, which did not work). This was 8 days ago, but I cannot confirm if I made a mistake or if Obitalk was acting up then?
These were previously configured devices that have been functioning properly and had responded to ObiTalk just fine over the past few months.
Anyone else having troubles like this? Is this a known issue with a fix?
Very frustrating...