OBi200 keeps rebooting after upgraded to 8680EX
glasgow:
Quote from: Taoman on August 24, 2021, 11:59:12 am
Quote from: glasgow on August 24, 2021, 10:28:08 am
I just got my answer from a Reddit user, Trunk Group is the culprit here.
Actually, that was me. ;D
Hah this is really a small world/internet! :D
azrobert:
You can get Trunk Group1 working by using OBi Expert to make the following changes.
Physical Interfaces -> Phone1 Port -> PrimaryLine: SP2 Service
Physical Interfaces -> Phone1 Port -> OutboundCallRoute
The last rule is {(Mpli):pli}
Change it to {(Msp2):tg1}
If the above doesn’t work, add this change.
Physical Interfaces -> Phone1 Port -> DigitMap
The last rule is (Mpli)
Change it to (Msp2)
Please post back if these changes work or not.
Taoman:
Quote from: azrobert on August 24, 2021, 07:53:13 pm
If the above doesn’t work, add this change.
Physical Interfaces -> Phone1 Port -> DigitMap
The last rule is (Mpli)
Change it to (Msp2)
Please post back if these changes work or not.
It works. Needed to edit DigitMap also. However, I couldn't get VGs to work in the Trunk Group. It would only fail over to another SP. Maybe it doesn't work with VGs?
azrobert:
Quote from: Taoman on August 24, 2021, 08:20:58 pm
However, I couldn't get VGs to work in the Trunk Group.
I have a VG in my Trunk Group and it works.
You can use a TG for normal routing to a provider, not just failover. That is what I’m doing with a VG. I don’t know if that makes a difference.
When you had to change the DigitMap to get the TG working, was the PrimaryLine set to tg1 or spx?
Taoman:
Quote from: azrobert on August 24, 2021, 09:21:29 pm
When you had to change the DigitMap to get the TG working, was the PrimaryLine set to tg1 or spx?
PrimaryLine is set to SP1.
It was strange. My TG1 looks like: (SP1, VG8, SP2, VG6)
I disabled SP1 to test and when calling I could hear a SIT Tone lasting about 1 second (when trying VG8) and simultaneously ringing (when trying SP2) over the top of that SIT Tone. Then SP2 connected successfully.
Can you give me an example of how you're using a TG "for normal routing to a provider?"
Navigation
[0] Message Index
[#] Next page
[*] Previous page