Cannot add device...
RonR:
Quote from: Necroman on November 21, 2011, 04:24:37 pm
I do not know how to reconfigure the unit manually.
Dial ***1 and write down the IP address that's reported.
Place that IP address in your web browser's address line and hit return.
When prompted for a username and password, use admin and admin.
Then follow the instructions in this post:
http://www.obitalk.com/forum/index.php?topic=1867.msg11986#msg11986
Remember to click on Submit at the bottom of any page you've made changes to before leaving that page.
When all changes have been made, click on Rebbot in the upper right corner to make all changes effective.
Necroman:
It turned out to be the router my dlink dir 825 was blocking the traffic. My original post should have read no ip not so ip. Thanx for the response. My computer ap still does not work even though :) all else is good. Using the soft phone xlite 4 results in a busy signal when I call anyone except my obi number.
RonR:
Quote from: Necroman on November 23, 2011, 08:56:19 am
My computer ap still does not work even though :) all else is good. Using the soft phone xlite 4 results in a busy signal when I call anyone except my obi number.
You may want to take a look at : Single-Stage Dialing Through Any OBi Trunk
Jean:
Quote from: RonR on November 10, 2011, 07:10:12 pm
It's easier and faster to configure the OBi without using the OBiTALK Web Portal.
Simply log into the OBi at the IP address returned by dialing ***1 using admin/admin.
Then set:
System Management -> Auto Provisioning -> ITSP Provisioning -> Method : Disabled
System Management -> Auto Provisioning -> OBiTALK Provisioning -> Method : Disabled
Google Voice on SP1:
Service Providers -> ITSP Profile A -> General -> Name : Google Voice
Service Providers -> ITSP Profile A -> General -> SignalingProtocol : Google Voice
Voice Services -> SP1 Service -> AuthUserName : (Google Voice username)
Voice Services -> SP1 Service -> AuthPassword : (Google Voice password)
Voice Services -> SP1 Service -> X_SkipCallScreening : (checked)
Physical Interfaces -> PHONE Port -> PrimaryLine : SP1 Service
Where can I find system management?
RonR:
Quote from: Jean on November 25, 2011, 10:51:12 pm
Where can I find system management?
See attached picture.
Navigation
[0] Message Index
[#] Next page
[*] Previous page