Cannot add device...
RonR:
Quote from: akxxxxxx on November 10, 2011, 09:34:44 pm
I tried logging in to the device, but cannot find those parameters (ITSP and OBiTALK Provisioning) in order to disable them.
In the navigation pane on the left side...
Click the + in front of System Management
Click on Auto Provisioning
In the right pane, find ITSP Provisioning -> Method
In the right pane, find OBiTalk Provisioning -> Method
RonR:
akxxxxxx,
If you haven't updated the firmware to v1.3.0, there is only one Auto Provisioning -> Method.
akxxxxxx:
Yes. I actually needed to update the firmware. THen I could find the parameters.
So, I can now make phone calls out. I was wondering if I would see my device now in the OBi Dashboard, so I can configure the other parameters like 7 digit dialing, etc.?
RIght now, I do not see my device in the OBi Dashboard.
Thanks
RonR:
I don't use the OBiTALK Web Portal, so I can't be of much help with it.
7-digit dialing is also easy:
Service Providers -> ITSP Profile A -> General -> DigitMap:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|<1aaa>[2-9]xxxxxx|011xx.|(Mipd)|[^*]@@.'@'@@.)
where aaa is your local area code.
Necroman:
:'( I cannot get my obi110 to be recognized in the dashboard after dialing the number and hearing it repeated. All that occurs is "failed to make connection". I can see so ip address for the device using the ipconfig command. I do not know how to reconfigure the unit manually. A reset yielded no results.
Navigation
[0] Message Index
[#] Next page
[*] Previous page