Digitmap Help
RonR:
Quote from: Thunnderman on November 12, 2011, 05:06:31 pm
However, if I dialed 001 or 0080 thru another obi unit by using speed dial likes 2*001... or 2*0080..., no replacement of 0088 done as call history shown exactly the original number.
Are you using this configuration? : http://www.obitalk.com/forum/index.php?topic=1103.0
If so, is the first rule in the receiving OBi's OBiTALK InboundCallRoute? : {(Mcot)>(Mli):li}
because you want the PrimaryLine in that OBi to be the LINE Port from the other OBi's perspective.
Thunnderman:
I tried to follow your listed instruction before but failed so went back to original setting. Will try to do it again and whether it can work, keep you posted. Thanks.
Thunnderman:
RonR,
I followed your instruction listed, 2 issues existed.
1. Can't make an outside call by using 2*any number by another obi unit. All calls received by AA
2. Can't make an call thru SP2 (2**2+any number) if I called by another obi unit.
No sure something wrong interpretation of below instruction? I put exactly the same into InboundCallRoute.
Voice Services -> OBiTALK Service -> InboundCallRoute:
{(Mcot)>(Mpli):pli},{(Mcot)>(<*1:>(Msp1)):sp1},{(Mcot)>(<*2:>(Msp2)):sp2},{(Mcot)>(<*8:>(Mli)):li},
{(Mcot)>(<*9:>(Mpp)):pp},{(Mcot)>(<**1:>(Msp1)):sp1},{(Mcot)>(<**2:>(Msp2)):sp2},
{(Mcot)>(<**8:>(Mli)):li},{(Mcot)>(<**9:>(Mpp)):pp},{(Mcot):aa},{ph}
Note: Replace pli above (2 places) with the OBi's PHONE Port -> PrimaryLine trunk name (sp1,sp2,li,pp,tg1) as the OBi won't do it for you.
RonR:
Did you change pli (2 places) in the rule : {(Mcot)>(Mpli):pli}
to match the PrimaryLine in that unit (sp1,sp2,li,pp,tg1)?
If your PrimaryLine is SP1 Service, you would use : {(Mcot)>(Msp1):sp1}
Thunnderman:
It works now after I changed {(Mcot)>(Mpli):pli} to {(Mcot)>(Mli):li}, just remove the 'p'.
The last issue is I can't make a call thru AA or speed dial (2**2+any number) to another obi's SP2, it always says "(500 Server Internal Error)".
Navigation
[0] Message Index
[#] Next page
[*] Previous page