News:

On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

How to setup aa and call forward with sp1 only

Started by UncleBill, November 16, 2011, 10:08:28 AM

Previous topic - Next topic

UncleBill

I would like to setup my new obi110 to go to aa if I called from my cell phone. If someone else called in, it will forward the call to my cell. I have only 1 sip service provider and 1 DID provided by this same service provider. What will be the setting to get this job done? Any help will be appreciated. Thanks.

RonR

Voice Services -> SP1 Service -> X_InboundCallRoute : {12341234567:aa},{sp1(12341234567)}

where 12341234567 is the CallerID of your cell phone as shown in Call History.

UncleBill

Hi RonR, thanks for your quick reply.

Actually, I tried this setting myself. If I called in from my cell, I get to aa without any issue. If I called in with different phone, it ring the phone attached to the device instead of forward the call to my cell. Also, The setting

Voice Services -> SP1 Service -> X_InboundCallRoute : {12341234567:aa},{sp1(12341234567)}

will changed back to

Voice Services -> SP1 Service -> X_InboundCallRoute : {12341234567:aa},{ph}

sometime.

Anything else you can think of that I can give it a try? Thanks.

RonR

If you're making the changes directly to the OBi, you must also set:

System Management -> Auto Provisioning -> ITSP Provisioning -> Method : Disabled
System Management -> Auto Provisioning -> OBiTALK Provisioning -> Method : Disabled

UncleBill


UncleBill

After put in the following setting:

System Management -> Auto Provisioning -> ITSP Provisioning -> Method : Disabled
System Management -> Auto Provisioning -> OBiTALK Provisioning -> Method : Disabled

The following works as expected:

Voice Services -> SP1 Service -> X_InboundCallRoute : {12341234567:aa},{sp1(12341234567)}


RonR, thanks again for your prompt reply.