S0 NOT WORKING? 1.3.0 Build:2586
RonR:
The only changes to the default PHONE Port DigitMap and OutboundCallRoute are shown in bold.
You should not need to use S0's.
Physical Interfaces -> PHONE Port -> DigitMap:
([1-9]x?*(Mpli)|[1-9]S9|[1-9][0-9]S9|1xx|**0|***|#|**1(Msp1)|**2(Msp2)|**8(Mli)|**9(Mpp)|(Mpli))
Physical Interfaces -> PHONE Port -> OutboundCallRoute:
{([1-9]x?*(Mpli)):pp},{(<#:>|1xx):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},
{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}
Physical Interfaces -> PHONE Port -> PrimaryLine : PSTN Line
Physical Interfaces -> LINE Port -> DigitMap:
(<+9722>[2-9]xxxxxx|<0:+972>[2-9]xxxxxxx|<0:+972>7xxxxxxxx|1xxxxxxxxx|05xxxxxxxx|<00:+>xx.|
<00:+>44xxxxxxxxxx|<**1>0<044:>8xx.|<**2><00:>1xxxxxxxxxx|<+:**00>xx.|<#>*xxxx|#*xxxx)
Service Providers -> ITSP Profile A -> General -> DigitMap:
(xx.|(Mipd)|[^*]@@.'@'@@.)
Service Providers -> ITSP Profile B -> General -> DigitMap:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.)
mrjoe:
Thank you so much for that!
I really appreciate it.
I first changed everything then rebooted.... the Obi110 went into a Reboot Loop!
I then reset, restored and changed each aspect rebooting after each page and it is now superb.
Weirdly calls go through faster now?
Also I now have a clearer picture of how these things work.
Thanks again RonR!
mrjoe:
RonR, One more question,
Is it possible for me to use a Calling Card to dial through Skype by using the DigitMap?
What I would like to do is:
When I call 00447xxxxxxxxx Obi should send 00441133221100 to Skype then wait the required 24 seconds and enter the 00447xxxxxxxxx followed by a #
Thanks
RonR:
Quote from: mrjoe on November 20, 2011, 04:08:32 pm
Is it possible for me to use a Calling Card to dial through Skype by using the DigitMap?
I don't believe so.
mrjoe:
Hi RonR,
What is the last rule on the Line Digitmap for #*xxxx is the preceding one not enough?
Thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page