Setting up 2 Obi110 in different locations

<< < (2/2)

FrankHaynes:
This is really good and useful info, which is why this is SCREAMING for a wiki to make it easier to index and keep it from scrolling off into posterity.

Ostracus:
Quote from: FrankHaynes on December 12, 2011, 07:13:44 pm

This is really good and useful info, which is why this is SCREAMING for a wiki to make it easier to index and keep it from scrolling off into posterity.


Agreed, and I'm wondering why it hasn't happened already?

MrGadget:
Quote

Example for routing calls to other locations.

From Location2:
...
All CALLS NOT listed above, Use Service Provider1 (yet to be configured GV)

Ooops. Sorry.
I should have stated that GV would be setup at Location1 using SP1 (I thought it, but didn't state it).  Is this possible, or does Location2 need to have an account with GV also? I would like to route through one GV account, if possible.

Thanks.

This is great stuff. And I agree too, a Wiki is needed here. Reading thousands of posts is unrealistic, even searching them is troublesome.

bukzin:
Wow, looks a bit involved for us newbies!


Is the a simple step by step version of this without all of
the 'under the hood' details?

Thanks!

RonR:
Quote from: MrGadget on December 23, 2011, 08:37:19 am

Quote

Example for routing calls to other locations.

From Location2:
...
All CALLS NOT listed above, Use Service Provider1 (yet to be configured GV)

Ooops. Sorry.
I should have stated that GV would be setup at Location1 using SP1 (I thought it, but didn't state it).  Is this possible, or does Location2 need to have an account with GV also? I would like to route through one GV account, if possible.


This is pretty much out of control at this point.  If you'd like help with a particular configuration, please start your own thread and state very specifically what you would like to accomplish.

Navigation

[0] Message Index

[*] Previous page