News:

On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

Obi 100 stops internet connection after first test

Started by edusobi, December 28, 2011, 09:11:01 PM

Previous topic - Next topic

edusobi

Hello,
I recently bought a second unit (Obi100) to connect to a second router in a different location than my first unit.

After plugging the unit to the router, I can make the test call to **9 222 222 222. However, the internet stop working after that, and the OBi and the computer connected to the same router cannot connect to the Internet any more.
I can only connect to the internet after rebooting the router without the OBi coonnected to it.

Any help would be greatly appreciated!

Thanks a lot!!

RonR

It's a total shot in the dark, but you might try changing the OBi Ethernet port from 10mbs/half-duplex to 100mbs/full-duplex:

1. Dial *** 0

2. Enter option 27 and press #

3. Press 1 to set a new value

4. Enter a value of 1 and press #

5. Press 1 to confirm/save

6. Hang up

7. Wait for the OBi to reboot

Diana

How can you tell if your OBi setup is operating at 10mbs/half-duplex vs 100mbs/full-duplex?

Quote from: RonR on December 28, 2011, 09:17:46 PM
It's a total shot in the dark, but you might try changing the OBi Ethernet port from 10mbs/half-duplex to 100mbs/full-duplex:

1. Dial *** 0

2. Enter option 27 and press #

3. Press 1 to set a new value

4. Enter a value of 1 and press #

5. Press 1 to confirm/save

6. Hang up

7. Wait for the OBi to reboot


RonR

Quote from: Diana on December 29, 2011, 03:38:08 AM
How can you tell if your OBi setup is operating at 10mbs/half-duplex vs 100mbs/full-duplex?

The default is 10mbs/half-duplex.

***0/option 27 reports the current value before allowing you to change it:

0 = 10mbs/half-duplex
1 = 100mbs/full-duplex