**8 Dialing failure

(1/2) > >>

Aswath:
I have connected Obi110 to GV and PSTN. When I dial **8 to access PSTN line, there is a noticeable delay after completing the dialing, then I hear a ringback, then a click sound. Then sometimes, the call completes to the dialed phone and sometimes the call fails. Is something wrong in my setup?

Stewart:
Instead of using **8, dial # and wait for dial tone from the PSTN line.  Then, dial the destination number.

If the above is undesirable, see whether increasing DialDelay for the LINE port from 500 to 1000 helps.  If not, look at Call History and report whether failed calls show the correct number being sent to the PSTN line.

RonR:
Quote from: Aswath on January 07, 2012, 06:07:52 am

I have connected Obi110 to GV and PSTN. When I dial **8 to access PSTN line, there is a noticeable delay after completing the dialing, then I hear a ringback, then a click sound. Then sometimes, the call completes to the dialed phone and sometimes the call fails. Is something wrong in my setup?


What is the contents of:

Physical Interfaces -> LINE Port -> DigitMap

and what is the format of the numbers you need to dial through the line port.

Aswath:
Quote from: RonR on January 07, 2012, 11:55:23 am

Quote from: Aswath on January 07, 2012, 06:07:52 am

I have connected Obi110 to GV and PSTN. When I dial **8 to access PSTN line, there is a noticeable delay after completing the dialing, then I hear a ringback, then a click sound. Then sometimes, the call completes to the dialed phone and sometimes the call fails. Is something wrong in my setup?


What is the contents of:

Physical Interfaces -> LINE Port -> DigitMap

and what is the format of the numbers you need to dial through the line port.



the contents of Physical Interfaces -> LINE Port -> DigitMap is (xxxxxxxS4|1xxxxxxxxxx|xx.)

and the format NANP.

Aswath:
Quote from: Stewart on January 07, 2012, 06:21:53 am

Instead of using **8, dial # and wait for dial tone from the PSTN line.  Then, dial the destination number.

If the above is undesirable, see whether increasing DialDelay for the LINE port from 500 to 1000 helps.  If not, look at Call History and report whether failed calls show the correct number being sent to the PSTN line.



I will try that. Meanwhile, my q is, I just plugged a new device with everything default and PSTN is VZ POTS. That is why it is puzzling to me why I am encountering this problem.

Navigation

[0] Message Index

[#] Next page