Line Out only works once after I reboot
Judgeless:
I have an OBI110 and a Panasonic KX-T61610 PBX. The OBI110 Phone port is connected to CO3 and the Line Out is connected to EXT17.
When I connected to the OBI110 and press # I get a dial tone from the KX-T61610 and I can page other phones in the house or dial out other central office numbers on the box. When I disconnect and try it again I get the voice error. {There is no service available to complete your call}. If a reboot the device it works perfect again. The second time I try it I get that message again. It does not matter how long I wait between calls.
When I dial **8 I never get a dial tone. Should I get a dial tone? If I dial **812 it will call extension 12. When I try it a second time I get the voice error {There is no service available to complete your call}.
RonR:
Dialing only a # on the OBi immediately bridges the PHONE Port to the LINE Port.
Receiving 'There is no service available to complete your call' when you dial only a # means the OBi thinks the LINE Port is not connected.
You must dial a complete number following **8 before the OBi will go off-hook on the LINE Port. It will then wait 0.5 seconds and begin dialing the number your entered following **8.
Again, receiving 'There is no service available to complete your call' means the OBi thinks the LINE Port is not connected.
Judgeless:
If I cycle power to the Obi and press # I get a dial tone. After I am done I hang up the phone. When I pick up the phone the second time and press # I get the voice message. {There is no service available to complete your call}
It works perfect after a reboot. After that it does not work again until I reboot.
RonR:
Quote from: Judgeless on January 07, 2012, 01:03:17 pm
If I cycle power to the Obi and press # I get a dial tone. After I am done I hang up the phone. When I pick up the phone the second time and press # I get the voice message. {There is no service available to complete your call}
Connect a splitter to the OBi LINE Port and connect a telephone in addition to the EXT17 line. After you've hung up from the successful access and the OBi is now reporting the error, does the telephone get dialtone and can you make a call from it instead of the OBi?
RonR:
Also, does the OBi work correctly connected to a normal POTS line?
Navigation
[0] Message Index
[#] Next page