Line Out only works once after I reboot
Judgeless:
Everything is working great. Thank you so much for your help. I never would have figured all this out with out your advice. I have two more OBi110's on order. When they arrive I am going to port my CO numbers and save myself a boat load of money.
Judgeless:
I have a new issue. When ‘Telco Line’ receives an incoming call it waits 2 second then sends it to the ‘Phone’ port. How do I turn this off? I do not have any forwarding turned on.
RonR:
CallerID is sent between the first and second ring. Consequently, the OBi has to wait for CallerID to be decoded for call routing and in order to re-encode it for display on the PHONE Port.
If you don't care about CallerID and call routting, you can set:
Physical Interfaces -> LINE Port -> RingDelay : 0
Judgeless:
Quote from: RonR on January 09, 2012, 04:34:23 pm
Physical Interfaces -> LINE Port -> RingDelay : 0
That did not fix the issue. When the Line port receives an incoming call it rings the line connected to the phone port after 2 seconds.
Judgeless:
I noticed under Physical Interfaces-> LINE Port-> InboundCallRoute-> it is set to ph. I assume that means to route to phone. I made it blank and it still routes the the phone port.
Navigation
[0] Message Index
[#] Next page
[*] Previous page