Line Out only works once after I reboot
Judgeless:
Quote from: RonR on January 07, 2012, 01:11:59 pm
Connect a splitter to the OBi LINE Port and connect a telephone in addition to the EXT17 line. After you've hung up from the successful access and the OBi is now reporting the error, does the telephone get dialtone and can you make a call from it instead of the OBi?
That is a good idea. I just tried it and do get a dial tone on the phone and I can make a call. When I dial # with the OBi I get {There is no service available to complete your call}
Judgeless:
Quote from: RonR on January 07, 2012, 01:14:38 pm
Also, does the OBi work correctly connected to a normal POTS line?
Yes
RonR:
I suspect tbe EXT17 line has lower than normal battery voltage or current.
Try to confirm this by setting:
Physical Interfaces -> PHONE Port -> EnableLINEPortBargeIn : (checked)
If you can now use # repeatedly, you will problably need to make an adjustment or two at:
Physical Interfaces -> LINE Port -> Port Settings -> LineInUseVoltageThreshold
and/or
Physical Interfaces -> LINE Port -> Port Settings -> LineInUseCurrentThreshold
and/or
Physical Interfaces -> LINE Port -> Port Settings -> MinOperationalLoopCurrent
Some measurements with a multimeter would probably help your decision making.
Judgeless:
Quote from: RonR on January 07, 2012, 01:24:57 pm
Physical Interfaces -> PHONE Port -> EnableLINEPortBargeIn : (checked)
That fixed the issue.
Quote from: RonR on January 07, 2012, 01:24:57 pm
If you can now use # repeatedly, you will problably need to make an adjustment or two at:
Physical Interfaces -> LINE Port -> Port Settings)
What do you suggest that I change?
Judgeless:
I went down to 20V and 9mA and it seems to work now. Thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page