Help with outgoing caller ID number...

(1/3) > >>

slicemaster:
Well, I'm new to the Obihai line of products but I have managed to configure and use my CallWithUs SIP account. Anyways, I am coming from a Sipura device and one that device i was able to set the outgoing caller ID.  This is important because by default CallWithUs sends out my users name for their service which is pointless... Is there a setting I can change on my obihai to force it to send out my DID number from ipkal? this is what I could do with my spa-1001 but I'm not sure how to do it on the Obihai...

PLEASE HELP!

P.S. I'm now familular with advanced configuration through the web interface, I've figured out what most the settings are but I have been unable to solve this issue and the CallWithUs support staff has never used any Obihai devices so they haven't been able to help either...

Stewart:
Under SIP Credentials, try putting your phone number in the URI field.

I'm not a CWU customer, so if that doesn't help, please describe all non-default settings that you have in the SPA1001 and I'll try to give you the corresponding OBi settings.  Of course, don't post actual phone numbers, account numbers or passwords, but make it clear what kind of information goes in each field.

slicemaster:
That worked great! put the number in the URI field and bam... thanks alot!

slicemaster:
oops...spoke too soon... now with that number in the uri field it won't register...

ADDITIONAL NOTE: With the number in the URI field I can still make outgoing calls with CWU... however the ATA does not register with CWU's servers so I can't recieve calls.... the obihai is reporting a registration failure with
this is what it states for the status on the obihai 110 - "Register Failed: 403 Forbidden auth ID"

any other ideas? why would this affect the registration?

the only thing that explains this as far as i'm concerned is that the obihai is using the uri field for registration when it's not blank....this is stupid! Why is the device using the URI and not the AuthID for registration attempts... makes no sense.... e-mail CWU, I expect they'll be able to shed some light...

Stewart:
OK, so try: reset the URI field to blank, turn on X_SpoofCallerID for the SPx in question,
and put the desired caller ID in OutboundCallRoute for the PHONE port, e.g. changing
{(<**1:>(Msp1)):sp1} to {(<**1:>(Msp1)):12121234567>sp1}

I don't know whether you need 10 or 11 digits for the phone number; use what you had originally in URI.

If still no luck, post details about SPA1001 setup.  Worst case, we can use SIP Debug on both devices to see what's different.

Navigation

[0] Message Index

[#] Next page