Long delay after answering incoming call
DonB:
I don't have this issue, but just curious is this only happening to those that use 2 different providers for incoming and outgoing, or does this also have to a single provider setup ??
JohnBowler:
It happened to me when I was just using GV, but I did have two GV accounts on my 202 at the time. I don't think it's happened to me in the last few days, but I have been rebooting my 202 quite often (because I've been making configuration changes.)
John Bowler <jbowler@acm.org>
DavidP:
I am also having this problem. I hope someone from OBi will respond. Two things seem to fix it for me:
1. Making sure I don't have the stuttering dial tone
2. Rebooting OBi 100 by unplugging it.
Ostracus:
Might syslog provide a clue?
JohnBowler:
Quote from: Ostracus on June 29, 2012, 03:45:54 pm
Might syslog provide a clue?
Possibly; have you used it successfully? I know that, given time, that I can set it up since I have at least one Linux system that I'm sure can accept the remote syslog messages, but I've never done it... Also I know it's an option on the 202, which is runing 2.6.30 on a fairly reduced uClibC/busybox system, but is it an option on the 100 or 110?
I'm also not sure that the Obihai stuff, which does most of the work in the 202, will actually use syslog to record its problems though, since they provide the option of remote syslog in the UI, I guess this is fairly likely.
John Bowler <jbowler@acm.org>
Navigation
[0] Message Index
[*] Previous page