911 Mapping
RonR:
Quote from: Clarke33 on January 25, 2012, 09:33:31 pm
How do I get to the settings to enter this?
If you wish to use the OBiTALK Web Portal : OBi Expert Configuration (Introduction)
I find it much simpler to access the OBi directly at the IP address returned by dialing ***1. The default username/password is admin/admin (the password may have been changed by the OBiTALK Web Portal if you have added the OBi to the Dashboard there).
If you wish to configure the OBi directly, you also need to set:
System Management -> Auto Provisioning -> ITSP Provisioning -> Method : Disabled
System Management -> Auto Provisioning -> OBiTALK Provisioning -> Method : Disabled
Clarke33:
Thanks I'll give it a try. I'll probably have more questions though.
Clarke33:
What is the easiest way to add Anveo to sp2.
RonR:
Quote from: Clarke33 on January 26, 2012, 05:18:13 pm
What is the easiest way to add Anveo to sp2.
Try this:
Service Providers -> ITSP Profile B -> General -> Name : Anveo
Service Providers -> ITSP Profile B -> SIP -> ProxyServer : sip.anveo.com
Voice Services -> SP2 Service -> X_ServProvProfile : B
Voice Services -> SP2 Service -> AuthUserName : (sip username)
Voice Services -> SP2 Service -> AuthPassword : (sip password)
Voice Services -> SP2 Service -> CallerIDName : (callerid name)
Everton:
In addition to what Ron shows below, DogFace05 (dslreports.com) recomends the following:
---------------------------------------------------------------------------------------------------------
Browse to Service Providers -> ITSP Profile B -> General and enable X_SymmetricRTPEnable. If that doesn't solve your problem, you may need to forward UDP ports 16800 through 16999 from your router to the OBi.
Also, given that Anveo use DNS SRV, it's nonsensical to explicitly specify their proxy server host and port. Under Service Providers -> ITSP Profile B -> SIP, just set ProxyServer to "anveo.com", and check Default for everything from ProxyServerPort through OutboundProxyPort. Enable X_DnsSrvAutoPrefix, and optionally (not really useful for now, since Anveo's DNS SRV records only map to a single proxy server) X_ProxyServerRedundancy.
-----------------------------------------------------------------------------------------------------------
Note: Anveo's DNS SRV records NOW map to a two proxy server!!
http://www.dslreports.com/forum/r26679801-Pls-help-Dead-air-with-Anveo~start=20
Quote from: RonR on January 26, 2012, 05:35:11 pm
Quote from: Clarke33 on January 26, 2012, 05:18:13 pm
What is the easiest way to add Anveo to sp2.
Try this:
Service Providers -> ITSP Profile B -> General -> Name : Anveo
Service Providers -> ITSP Profile B -> SIP -> ProxyServer : sip.anveo.com
Voice Services -> SP2 Service -> X_ServProvProfile : B
Voice Services -> SP2 Service -> AuthUserName : (sip username)
Voice Services -> SP2 Service -> AuthPassword : (sip password)
Voice Services -> SP2 Service -> CallerIDName : (callerid name)
Navigation
[0] Message Index
[#] Next page
[*] Previous page