Minor annoyance - can't log into Obi's internal config page...

(1/1)

TheoGeek:
So, I think this happened when I switched my Obi 110 to have a static IP, but I'm not sure.  I had been able to enter the IP of the Obi in a web browser and login just fine, so I know it "used" to work.  Now, when I try, I get the login prompt, but it just times out after I enter the username and password.  I can get to the settings through the Obi portal on the web.

Any clues?  I'd really like to not have to reset the box to factory settings, but I don't have a whole lot of stuff that I'd need to reconfigure.

The funny thing is that the Obi is operating just fine except that I can't log into it.  Well, that and when I tried to reenable DHCP through the *** menu to see if that was the problem, it never stuck (it would say "Enabled", but switch right back to "Disabled" again)

Thanks!
Jeff.

RonR:
Look on the OBiTALK Web Portal to see if it changed your OBI's password.

TheoGeek:
So, the password on the Obitalk web portal was what I expected.  However, I changed it to something else and now my old password works to log into my Obi.  Strange.  The password I use to log into my Obi is NOT the password listed in the admin section of the Obitalk web portal. 

I don't remember turning "auto update" (or whatever) off, but I may have.  But I didn't change the password on my Obi, just on the Obitalk portal.

Oh well, it works now.  :)

Navigation

[0] Message Index