Help for the clueless, can't dial out on a landline phone
jimates:
I know that you can make it dial out on SP1 and also make it dial a certain number (emergency number) should anyone dial 911 from the phone connected to the Obi. Since I only have GV I was going to set mine up to do that but just haven't invested the time to figure it out.
I am sure that RonR knows how to configure it. But whether he can tell us in simple terms we can understand, I do not know.
RonR:
As I said, 911 goes to the landline port by default. If you want 911 to dial some number on SP1, that can be accomplished also.
lincdeko:
Quote from: RonR on February 28, 2011, 11:07:55 pm
As I said, 911 goes to the landline port by default. If you want 911 to dial some number on SP1, that can be accomplished also.
How would we do that?
She is not using the line port at all. Her landline has a set of phones and her obihai has a set and they will have nothing to do with each other so dialing 911 won't go anywhere because it won't have access to the landline.
RonR:
To make 911 dial an alternate number on SP1, replace the first route in Phone Port OutboundCallRoute:
Code:
{(<#:>|911):li},
with
Code:
{(<911:???????????>):sp1},{(<#:>):li},
where Code:
???????????
is a valid number for the SP1 provider.
jimates:
lincdeko,
and did you change the primary line on the Obi to SP1, so she won't have to dial **1 to place calls from it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page