Israel disconnect tone
bhdira:
My line port is not disconnecting and I think because the only thing I get on disconnect is a fast busy. I have attached a recordings of it, would anyone be able to tell me what the value of it is?
Thanks
Stewart:
Set LINE Port -> DisconnectTonePattern to 400-30;10;(.5+.5)
This should disconnect after 10 seconds. You can change the 10 to a smaller value to get a quicker disconnect, at increased risk of falsely detecting the pattern, e.g. in hold music.
bhdira:
Quote from: Stewart on February 07, 2012, 08:31:36 am
Set LINE Port -> DisconnectTonePattern to 400-30;10;(.5+.5)
This should disconnect after 10 seconds. You can change the 10 to a smaller value to get a quicker disconnect, at increased risk of falsely detecting the pattern, e.g. in hold music.
It works Thanks a ton
Btw is 10 representing seconds?
Stewart:
Quote from: bhdira on February 07, 2012, 02:52:55 pm
Btw is 10 representing seconds?
The manual implies that, but I am not certain. Possibly, it represents 10 repetitions of the pattern. However, in your case, the pattern is exactly one second long, so it means 10 seconds anyway.
bhdira:
Quote from: Stewart on February 07, 2012, 04:37:56 pm
Quote from: bhdira on February 07, 2012, 02:52:55 pm
Btw is 10 representing seconds?
The manual implies that, but I am not certain. Possibly, it represents 10 repetitions of the pattern. However, in your case, the pattern is exactly one second long, so it means 10 seconds anyway.
interesting that it actually disconnects in under 10sec now so any one know what it represents?
Just curious.
Navigation
[0] Message Index
[#] Next page