Add Wireless Networking to the unit.
guyinsb:
Built-in wifi makes for less clutter. I would buy 25 for my vacation condo rental pool.
We have 5 wifi routers scattered about the condo, but do not have Ethernet to most units.
But the market demand may not be that big.
guyinsb:
On the other hand, small hotels could get rid of their expensive and hard to maintain pbx systems.
jb317:
Another vote here for added wi-fi capability. Sure, a wireless bridge is an option, but requires additional hardware and knowledge. Built in wi-fi adds simplicity.
guyinsb:
Other reasons for built-in wifi:
- assuming the product still has an Ethernet port, it can itself be sold into two additional markets:
1. wireless bridge
2. wireless ATA
- it may soon be the case that many residences will obtain internet access strictly using their 4G phones as MiFi hotspots
In this case, there is no Ethernet connection available
daibaan:
Quote from: RonR on March 08, 2011, 10:12:36 am
Quote from: biomesh on March 08, 2011, 06:39:58 am
Or just use another ethernet switch. Most "combo" devices tend to have issues due to the overly complex nature.
That's fine if you have Cat5 going to where you need it. For inaccessible locations, a router configured as a wireless ethernet bridge is an extremely simple and reliable solution. I've been using it for years to connect my TiVo and DirecTV DVR's in the living room and bedroom to the Internet and haven't had any hiccups.
If I use a DD-WRT router in wireless bridge mode for remote access, does my main router need to be configured in bridge mode too? or can I configure the main router to be in AP mode so that it can still serve other wireless clients and serve the remote router that is configured to be in bridge mode?
Navigation
[0] Message Index
[#] Next page
[*] Previous page