Adjust volume
JD1940:
Using Obi 1110 with Google Voice and Panasonic DECT 6 phones. Basically all is working well but the volume at least on the receiving end is quite loud. Where and how can I lower it and what setting would you suggest. I've already lowered the phone volume as low as it will go but I still get an occasional echo effect and I think it's because of the volume. Also had a caller say I was breaking up badly at his end although he sounded fine to me. I don't know whether that's because of volume or because I was downloading a large file and so perhaps had a router problem. I use Cox internet at the 15mbps/4mbps level. Any possible settings for that problem?
lk96:
one thing you can try is to (lower) the RxGain on the phone port:
PHysical interfaces -> PHONE -> channelRxGain
L.
lk96:
correction to my previous post: you will need to modify the
channelTxGain (not the Rx) to attenuate the signal from the Obi to the PHONE port.
L.
JD1940:
I see where those are but what's a reasonable reduction? They are both currently set at 0 which doesn't give me much to go on.
RonR:
Quote from: JD1940 on February 11, 2012, 11:17:07 am
I see where those are but what's a reasonable reduction? They are both currently set at 0 which doesn't give me much to go on.
Negative numbers reduce the volume, positive numbers increase the volume.
Simply try -1, -2, ..., -12 until you find the volume that suits you.
Navigation
[0] Message Index
[#] Next page