OBI110 and phone power configuration

(1/2) > >>

Name:
I have the SIP credentials from Phone Power. I have difficulty in getting the OBI110 to work with that service.

Error message:
Backing Off (xxxs):Authentication error

I am pretty sure the SIP password is good.

Where should I look in the OBI and check?

I have the following settings:

ITSP profile B
Signaling protocol SIP is enabled

SIP: server IP
all other settings are default

SP2 service
is enabled

Authusername and password are given
URI should be default or should I enter anything here?

RonR:
These are the only setttings (from Default) that usually need to be set for a SIP provider:

Service Providers -> ITSP Profile B -> General -> Name : (provider name)
Service Providers -> ITSP Profile B -> SIP -> ProxyServer : (proxy server)

Voice Services -> SP2 Service -> X_ServProvProfile : B
Voice Services -> SP2 Service -> AuthUserName : (sip username)
Voice Services -> SP2 Service -> AuthPassword : (sip password)
Voice Services -> SP2 Service -> CallerIDName : (callerid name)

Stewart:
My OBi works fine with Phonepower.  To work around a strange problem (with my router and another provider), I have the following under SP2 service, which may work for you:

AuthUserName (10-digit PP phone number, e.g. 2123456789)
AuthPassword (15 Hex digit password from PP; your password format might be different)
URI 2123456789@208.64.8.6

And under ITSP Profile B, SIP:

ProxyServer: 208.64.8.6
ProxyServerPort: 12060
RegistrarServer: 208.64.8.6
RegistrarServerPort: 12060

If no luck, post all information shown in SP2 Service Status.

Name:
Not working

I attached screen shots of SP2 service and ITSP profile B

Name:
ITSP profile B

Navigation

[0] Message Index

[#] Next page