New and need setup help with international calls

<< < (2/2)

RonR:
Quote from: moonspell2000 on March 10, 2012, 02:26:12 pm

I have a question, do I need to put the same Digitmap in both profile A & B?


The one for ITSP Profile A is different from the one for ITSP Profile B.

Quote from: RonR on March 10, 2012, 10:41:16 am

If Localphone uses 00+ for international calling, then use:


Service Providers -> ITSP Profile A -> General -> DigitMap:

(<1aaa>[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|<**2>011xx.)

where aaa is your local area code for 7-digit dialing.


Service Providers -> ITSP Profile B -> General -> DigitMap:

(<1aaa>[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|<011:00>xx.|00xx.)

where aaa is your local area code for 7-digit dialing.

moonspell2000:
RonR thanks for the help!

Everytime that I enter
Service Providers -> ITSP Profile A -> General -> DigitMap:
(<1610>[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|<**2>011xx.)
 
and reboot it is overwritten to:
(1xxxxxxxxxx|<1610>[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*]@@.)

How do I stop it?

RonR:
If you configure the OBi directly (as opposed to using the OBiTALK Web Portal), you must also set:

System Management -> Auto Provisioning -> ITSP Provisioning -> Method : Disabled
System Management -> Auto Provisioning -> OBiTALK Provisioning -> Method : Disabled

or the OBiTALK Web Portal will overwrite your changes.

moonspell2000:
RonR
Thanks for the help!  I just have to try a few more phone calls but so far it looks like it works.  I really appreciate the help.

moonspell2000

Navigation

[0] Message Index

[*] Previous page