How to prevent OBI from dialing speed dials?

<< < (2/2)

Felix:
OK, here are my observations:
I put [1-9] in the dial plan, and turned off provisioning; to simplify the testing. I found out that if the speed dial entry exists, it takes precedence over dial plan - no matter what I do.
If speed dial entry doesn't exist, then dial plan rules apply.

Would be great if the gurus here could confirm that it is not possible to override speed dial entries...

Thanks

RonR:
It appears that a check is made between the Digit Map Processor and the Outbound Call Route Processor for a dialed number of 1 - 99, and if the addressed Speed Dial is not empty, its contents is unconditionally substituted.  If the addressed Speed Dial is empty, then the dialed number is unchanged.

The result is what you've observed.  Dialing 1 - 99 always uses the addressed Speed Dial contents if it's not empty.  If the addressed Speed Dial is empty, then the dialed 1 - 99 number is sent to the Outbound Call Route Processor unchanged.

Navigation

[0] Message Index

[*] Previous page