Anveo and OBi100
RonR:
For some reason, Anveo is ignoring the leading '1' and taking the 64 that follows as a country code (New Zealand). Since the call wasn't completed at the destination, apparently Anveo doesn't list it in their Call History.
If all else fails, try adding the following to your configuration:
Service Providers -> ITSP Profile B -> SIP -> OutboundProxy : sip.anveo.com
Service Providers -> ITSP Profile B -> SIP -> OutboundProxyPort : 5010
lad130@gmail.com:
Dialing format is set to International. The CDR reports show the calls were logged. The duration and Status lines were blank.
Stewart:
Quote from: lad130@gmail.com on March 26, 2012, 11:01:18 am
The CDR reports show the calls were logged.
Does the number show as 1646xxxxxxx, 646xxxxxxx, or somthing else?
RonR:
Quote from: Stewart on March 26, 2012, 11:05:12 am
Quote from: lad130@gmail.com on March 26, 2012, 11:01:18 am
The CDR reports show the calls were logged.
Does the number show as 1646xxxxxxx, 646xxxxxxx, or somthing else?
It apparently left the OBi correctly:
Quote from: lad130@gmail.com on March 26, 2012, 10:29:05 am
Terminal ID PHONE1 SP2
Peer Name
Peer Number **21646xxxxxxx 1646xxxxxxx
Direction Outbound Outbound
10:10:17 New Call
10:11:01 End Call
lad130@gmail.com:
I doesn’t matter if I dial “1” or not I still get NZ. The Obi was already configured with those values.
Navigation
[0] Message Index
[#] Next page
[*] Previous page