Create digit maps

<< < (2/4) > >>

RonR:
Service Providers -> ITSP Profile A -> General -> DigitMap:

(*xx.|<123>xxxxxxxx|123xxxxxxxx|<321>xxxxxxxxxx|321xxxxxxxxxx|<**8>xx.)

Physical Interfaces -> PHONE Port -> PrimaryLine : SP1 Service

Physical Interfaces -> LINE Port -> DigitMap : (xx.)


* followed by any string of digits  ->  SP1 (unchanged)
8 digits  ->  SP1 (with 123 added at the beginning)
10 digits  ->  SP1 (with 321 added at the beginning)
any other string of digits   ->  LINE Port (unchanged)

HenriqueBR:
It doesn't work. :(
Would you care to explain this setup?

RonR:
Quote from: HenriqueBR on March 27, 2012, 11:53:51 am

It doesn't work. :(
Would you care to explain this setup?


There was an omission in my previous post.  Sorry 'bout that!

Please try the updated ITSP Profile A DigitMap.  I've tested it here and it appears to work as advertised now.

HenriqueBR:
hey, thanks, it works now.
would you care to explain these rules?

also if instead of adding a prefix, I wanted to remove, could I use something like
<123:>xxxxxxxxxx
so that when I enter 123 and a string of 10 other numbers, it removes the 123 and uses sp1

also it isn't using the normal phone line whenever the number called is of a length different than 8 or 10 digits

RonR:
You might want to start out by studying the OBi Device Administration Guide section entitled DIGIT MAP CONFIGURATION.

Navigation

[0] Message Index

[#] Next page

[*] Previous page