OBI110 latest firmware - cannot receive inbound GVoice calls
QBZappy:
DAVEHH,
This might be a situation where it might be simpler to add the GV account using the OBi portal. Make sure you have enabled the following settings in in the OBi unit:
System Management->Network Settings->ITSP Provisioning
System Management->Network Settings->OBiTalk Provisioning
DAVEHH:
@ STEWART:
Possibly, this is a NAT timeout issue. Test by making a call from the OBi, hanging up, then calling the GV number immediately (within 30 seconds).
I did as suggested, I can place outgoing calls however when I called my GV number, I heard a ring but OBI110 did not ring.
@QBZappy:
I used the dashboard to manage the GV account. No changes, it does not ring on incoming calls.
Any other suggestions?
QBZappy:
DAVEHH,
If you disconnect the OBi can you make a call using a phone and receive the call on the computer with GTALK? Do not use the phone you used to register GV with. It will send you to voice mail.
DAVEHH:
Quote from: QBZappy on April 05, 2012, 09:23:00 am
DAVEHH,
If you disconnect the OBi can you make a call using a phone and receive the call on the computer with GTALK? Do not use the phone you used to register GV with. It will send you to voice mail.
I see what you mean.
using GTALK within GV account interface does not complete an outgoing call.
QBZappy:
DAVEHH,
OBi has a builtin GTALK client inside. That's how it works with GV. If you have GV, you can use the GTALK client to make calls to telephone numbers as well. Did you make your obligatory first call using GV?
Did you know that you can have conversations with other GTALK users using the phone attached to the OBI.
Navigation
[0] Message Index
[#] Next page
[*] Previous page