Using "Import Config to OBi Expert" in OBiTalk
larrybob:
Try as i might, I can not get this to work. Has anyone had any success with this?
Larry
RonR:
This has been discussed several times in the recent past. Nobody reported being able to successfully import a saved configuration file into OBi Expert. I was not able to get it to work either.
ckdash:
Quote from: RonR on April 10, 2012, 10:01:38 pm
This has been discussed several times in the recent past. Nobody reported being able to successfully import a saved configuration file into OBi Expert. I was not able to get it to work either.
I'm a newbie to this, but I have just exported a config from my Obi110 and imported it to the OBi expert portal without any problems.
RFord:
Are your sure? In order for you to confirm that it is indeed working again, you must first remove the OBi110 from the OBiTALK portal, return the OBi110 to its default status (Reset the device) and then re-add the device to the OBiTALK portal and then import the saved config file and check to see if it was imported. You can't import the config file to an already configured setup, since you will not be able to discern whether the file was imported or not.
Quote from: ckdash on May 07, 2012, 07:07:52 am
Quote from: RonR on April 10, 2012, 10:01:38 pm
This has been discussed several times in the recent past. Nobody reported being able to successfully import a saved configuration file into OBi Expert. I was not able to get it to work either.
I'm a newbie to this, but I have just exported a config from my Obi110 and imported it to the OBi expert portal without any problems.
ckdash:
Quote from: RFord on May 07, 2012, 08:44:46 am
Are your sure? In order for you to confirm that it is indeed working again, you must first remove the OBi110 from the OBiTALK portal, return the OBi110 to its default status (Reset the device) and then re-add the device to the OBiTALK portal and then import the saved config file and check to see if it was imported. You can't import the config file to an already configured setup, since you will not be able to discern whether the file was imported or not.
Quote from: ckdash on May 07, 2012, 07:07:52 am
Quote from: RonR on April 10, 2012, 10:01:38 pm
This has been discussed several times in the recent past. Nobody reported being able to successfully import a saved configuration file into OBi Expert. I was not able to get it to work either.
I'm a newbie to this, but I have just exported a config from my Obi110 and imported it to the OBi expert portal without any problems.
Ah, well I didn't try that :)
I just did the import configuration.
I'll give it a try if you like. I have the saved configuration so it would be no big deal if it didn't work.
Navigation
[0] Message Index
[#] Next page