Using Google Voice for Long Distance and Local Carrier for Local Calls
ianobi:
Hmmm - anonymous benefactor and a digit map style that looks familiar - I reckon I could take a guess who that might be! Of course, I'm too much of a gentleman to mention a name :)
Sophia:
You just gotta love all the intrigue ;D ;D ;D
carl:
Quote from: ianobi on January 17, 2014, 12:11:01 pm
Hmmm - anonymous benefactor and a digit map style that looks familiar - I reckon I could take a guess who that might be! Of course, I'm too much of a gentleman to mention a name :)
never mention an unperson. ;D
ssturner66:
Hi Everyone,
My OBI110 has been working fine until I updated it the other day. Now my call routing that was set up no longer works. When I call from the local phone line connected to my OBI110 to my cell phone, the caller ID that shows up is my Google Voice Number whereas it used to be my local number as the call was a local call, not a long distance call.
I looked through the thread and found the posts by RonR about configuring my Primary Line and DigitMap. I looked at my OBI110 and the lines that used to be there are definitely different. I have tried on several occasions to replace the new lines with the ones that were in RonR's post but after I make the change, click submit at the bottom of the configuration page and reboot the OBI110, when it comes back on line, the line I entered is gone and replaced by what used to be there.
I need to change the PrimaryLine from SP1 Service to PSTN Line but nomatter what I do, it always reverts back to SP1 Service. Same thing for the DigitMap under the Physical Interfaces -> LINE Port -> DigitMap:.
Any suggestions?
Thanks.
Scott Turner
BB88:
Quote from: ianobi on November 27, 2012, 09:47:04 am
Sophia,
With FPL on sp1 and GV on sp2. Set:
Physical Interfaces -> PHONE Port -> PrimaryLine : SP1 Service
Service Providers -> ITSP Profile A -> General -> DigitMap:
([2-9]11S4|<250>[2-9]xxxxxxS4|[2-9]xxxxxxxxxS0|1xxxxxxxxxxS0|<**2>011xx.)
Service Providers -> ITSP Profile B -> General -> DigitMap:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.)
Calls will route as follows:
[2-9]11 -> three digit numbers starting with 2 to 9 > sp1
7 digits -> Obi adds 250 > sp1
10 digits -> that start with 2-9 > sp1
11 digits -> that start with 1 > sp1
011+ -> sp2
How do you change the DigitMap to route certain Canadian calls (11 digits) with specific area codes to SP1, and all other Canadian and US calls (11 digits) to SP2?
e.g.
10 digits -> 250, 530 > SP1
11 digits -> 1-234-xxxx, 1-567-xxxx > SP1 (the dashes are for reading purpose only)
all other 11 digits -> SP2
Navigation
[0] Message Index
[#] Next page
[*] Previous page