No dial tone since 2711 update
RFord:
Did you in anyway interrupted the firmware update while it was in progress?
RonR:
Quote from: gquiring on May 09, 2012, 03:40:35 pm
I was getting dial tone until the the update. Can I install the older firmware to test?
Obihai says you cannot revert below v1.3, but you should be able to install any of the released v1.3's:
OBi-1-3-0-2532.fw
OBi-1-3-0-2575.fw
OBi-1-3-0-2586.fw
OBi-1-3-0-2651.fw
OBi-1-3-0-2669.fw
OBi-1-3-0-2675.fw
OBi-1-3-0-2690.fw
OBi-1-3-0-2711.fw
gquiring:
Quote from: RonR on May 09, 2012, 03:49:44 pm
Quote from: gquiring on May 09, 2012, 03:40:35 pm
I was getting dial tone until the the update. Can I install the older firmware to test?
Obihai says you cannot revert below v1.3, but you should be able to install any of the released v1.3's:
OBi-1-3-0-2532.fw
OBi-1-3-0-2575.fw
OBi-1-3-0-2586.fw
OBi-1-3-0-2651.fw
OBi-1-3-0-2669.fw
OBi-1-3-0-2675.fw
OBi-1-3-0-2690.fw
OBi-1-3-0-2711.fw
The update went without any errors. Where are those downloads?
RonR:
Quote from: RFord on May 09, 2012, 03:48:56 pm
Did you in anyway interrupted the firmware update while it was in progress?
That's an inherent risk when firmware updates are pushed without your knowledge and consent.
RonR:
Quote from: gquiring on May 09, 2012, 03:51:35 pm
Where are those downloads?
http://www.obihai.com/firmware/OBi-1-3-0-xxxx.fw
where xxxx is the build number.
Navigation
[0] Message Index
[#] Next page
[*] Previous page