Power light blinking, no IP
0biUser5959:
Hi,
My Obi has suddenly stopped working after just a couple of months. The power light stays constantly blinking. I tried reseting it using the button under the unit, but I get the same problem. I checked the cables to make sure they are all tight. I went to the admin interface for my router and it does not show an IP for the Obi. I get an IP on my laptop when I connect to the same ethernet port using the same ethernet cable connected to the Obi. Don't know what else I can try, do I have any other recourse?
Thanks!
jimates:
Try one more thing before calling it dead.
Unplug the power
Hold the reset button with a paper clip
Reconnect the power, while holding the reset button.
Continue holding the reset button until the unit cycles. Could be up to 40 seconds.
0biUser5959:
Thanks for the tip. Didn't work though :(
RonR:
It's a long shot, but since you're out of things to try...
The following procedure will change the OBi Ethernet port from 10 mb/s half-duplex to 100 mb/s full-duplex:
1. Dial *** 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot
Songsw:
I'm having the same problem! Very disappointed...
I tried the reset button, didn't work.
Can't try the dial thing, because there is no dial tone either.
I guess it is dead :(
Navigation
[0] Message Index
[#] Next page