Power light blinking, no IP
aharond:
Power supply replacement worked for me, I tried a power brick from my old Vonage box and my OBi came back to life. I emailed OBi support and they are sending me a replacement power brick.
Thanks for the help everyone, I've been trying to figure this out for 2-3 months. I was going to order a new OBi device from Amazon as a last resort.
jjtricket:
Great news!
Looks like the power supply might be a common issue, also noticed many are having line noise, humming issues as well.
Many THANKS to Obi support for the prompt shipment of my new power adapter!
GregoryZ:
Quote from: jjtricket on August 31, 2012, 05:53:26 pm
Many THANKS to Obi support for the prompt shipment of my new power adapter!
I like seeing Posts like this!
Even though we see a lack of Written Support, both in Documentation of Upgrades, and most Forum Support, I do see that when a Ticket is submitted, that there is Good Customer Service in the end.
Just my Two Cents worth.
-G
Edit: Here is yet another example: http://www.obitalk.com/forum/index.php?topic=3862.msg26533#msg26533
GregSimon:
Quote from: 0biUser5959 on May 12, 2012, 12:28:21 pm
Hi,
My Obi has suddenly stopped working after just a couple of months. The power light stays constantly blinking. I tried reseting it using the button under the unit, but I get the same problem. I checked the led lighting to make sure they are all tight. I went to the admin interface for my router and it does not show an IP for the Obi. I get an IP on my laptop when I connect to the same ethernet port using the same ethernet cable connected to the Obi. Don't know what else I can try, do I have any other recourse?
Thanks!
hello were you able to sort out the problem? I am facing similar issue with my power light.. Can you tell the reason behind it.. Please reply
jeffAustin:
I have an obi 100 which has always and still works great. Just upgraded to an obi202 and it worked up until I tried to configure the anveo 911 support. Then the power led starting flashing green to red, and the dial tone was no longer available. I swapped the power supply with the 0bi100, the 100 still works, the 202 is still flashing. I do see an IP addr on my router for the 202. I have tried the factory reset several times to no avail. Any ideas left? I see lots of complaints about the 202 and this problem. Should I just return it and stick with the old reliable 100, I was hoping to get fax service, but with the amount of time I have into it not sure it is worth it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page