Need help to setup PSTN for OBI110

<< < (3/5) > >>

Qnewbie:
I am using ADSL for this landline. I am sure that it is properly filtered as other analog phones work perfectly. There is not other device shares this line(I pull out all other phones).

Should try to test other device latter. Otherwise, I can still use obi110 as obi100.

mikedib87:
Hi

I'm having the same issue in the UK.  Did this ever get resolved?

If so, how?

Thanks

ianobi:
mikedib87 - welcome to the forum.

Can you be more specific - what happens with an incoming PSTN call? Does it ring the phone attached to the OBi110? Can you answer? With outgoing calls can you get dial tone from the OBi? There may be long delays connecting due to digit map considerations. Are you using a British Telecom line?

Have a search on this forum for posts with "UK" in the title - there are quite a few.

mikedib87:
Hi ianobi

Thanks for the reply.

A PSTN call will ring the phone...but not consistently.  It will actually stop ringing and then restart ringing.  The logs see these as differing calls and log them separately.  I have tried the changes already outlined in this post.  I can't answer the call, when i pick up theres silence, then the phone goes down.  On the phone calling in, it just keeps ringing through.

It's a Cable Virgin Media line with a BT Connector.  The SIPgate service i've configured works flawlessly.  I can't dial out on the PSTN, I get service not available.

Thanks

ianobi:
Set all of these as follows:

Physical Interfaces > LINE Port > RingDelay: from 4000 to 0
Physical Interfaces > LINE Port > Port Settings > CallerIDDetectMethod to FSK(V.23)
Physical Interfaces > PHONE Port > Port Settings > CallerIDDetectMethod to FSK(V.23)

Physical Interfaces > LINE Port > PSTN Disconnect Detection > DetectPolarityReversal: Uncheck

Now try lower values for:

Physical Interfaces > LINE Port > Ring Detection > RingThreshold

Ring threshold may be a problem if you are on a long line or have other devices connected in parallel with your OBi.


Quote

I can't dial out on the PSTN, I get service not available.

This is suspicious! You may have a connecter problem between the BT style socket and the OBi . What happens if you pick up the phone connected to the OBi and press”#” – you should get PSTN dial tone. Also, with no active call ongoing, what voltage is recorded at:

Status > PHONE & LINE Status > Line Port Status > TipRingVoltage

Navigation

[0] Message Index

[#] Next page

[*] Previous page