Dial plan explanation
murzik:
Thanks RonR
Quote from: RonR on March 18, 2011, 08:10:15 pm
If you're using only these two rules together in the same DigitMap, it should work:
(1xxxxxxxxxxS0|<1aaa>[2-9]xxxxxxS0)
This is exactly what I have and I am running latest beta. But for some reason S0 have no effect.
RonR:
murzik,
I was told that S0 was fixed in build 2081. I'll try your case in a little while and report what I experience.
RonR:
murzik,
When I was about to start testing your DigitMap, it dawned on me that in this particular case, S0 won't have any effect because both rules are effectively S0 already. When either rule goes into the Exactly Matched state the other will be in the Mismatch state, so the DMP returns the matched rule's value immediately.
murzik:
RonR
If S0 is matched already, or S0 is working, then 11 or 7 digits US number should be dialed immediately after I press last digit. It should be as fast as I would have pressed # after last digit. But it is not.
RonR:
Quote from: murzik on March 19, 2011, 11:50:01 am
It should be as fast as I would have pressed # after last digit. But it is not.
There's no difference here. Is this your complete DigitMap (with or without any S0's)?:
(1xxxxxxxxxx|<1aaa>[2-9]xxxxxx)
Is your PrimaryLine pointing to this DigitMap (or you're explicity utilizing it using **?)? Please elaborate on the total picture.
Navigation
[0] Message Index
[#] Next page
[*] Previous page