Dial plan explanation
Stewart:
What, if anything, shows in Call History after a failing call?
If you have one or more phones connected directly to the PSTN line (as opposed to being connected to the OBi's PHONE port), it's normal for them to ring while the forward is being set up, and until the cell phone is answered.
Albert:
Dear Stewart
Yes, the call history after failing call show the caller number. I dont have any phone connected directly to PSTN line. When somebody call me throw my PSTN line port, it can't forward to Google Voice (SP1). The caller's phone continue ring and not forward to GV
Line Port> InboundCallRoute> SP1(my_cell_phone)
Regards
Albert
Stewart:
If you manually dial your cell phone number from the phone connected to the OBi (using GV), does the call work as expected? If not, troubleshoot that first.
If the manual call works ok, try another forwarded call. Allow at least 15 seconds (after the PSTN caller hears ringing) for your cell phone to ring. Then, log into the OBi and go to Status -> Call History. You should see several lines of information for the call in question. Confirm that the Peer Number for the Outbound side is correct. Then, post everything in the History for that call (mask the actual phone numbers).
What country / city is the OBi in?
Dogzipp:
Can anyone help a little. I am overwhelmed with the amount of options the Obi has, and I am not sure as to where exactly put things..
I want to use my LINE mainly for all calls, except:
Calls that start with 4 (8 digits) to go through SP1
Calls that start with 1 (11 digits) to go through SP2 (Google Voice).
Everything else through the PSTN (911, 1xxx and 8 digit calls that start with 2-3 and 5-8)
I was thinking about this:
Physical Interfaces -> Phone Port -> Primary Line : PSTN Line
Physical Interfaces -> Line Port -> Digitmap : (<**1>4xxxxxxxS0|<**2>1xxxxxxxxxxS0|xx.)
But I am not 100% sure.. I see some people do the digits maps directly on ITSP Profile A, but I guess that's when your main line is SP1?
I would appreciate any configuration help, on how to make things work.
RonR:
I would suggest:
Physical Interfaces -> PHONE Port -> PrimaryLine : PSTN Line
Physical Interfaces -> LINE Port -> DigitMap : (<**1>4xxxxxxx|<**2>1xxxxxxxxxx|911|1xxx|[2-35-8]xxxxxxx)
Each of these rules is an exact match, therefore no S0 is needed anywhere.
Navigation
[0] Message Index
[#] Next page
[*] Previous page