Dial plan explanation
RonR:
Looks good, but the real test is to plug it in and try the various patterns to make sure they do what you want.
The Call History will show you the outcome of each test.
Lowdough:
I'm using the OBI on Callcentric (port 2, the default port) and it's working great. Port 1 is Google voice and it's working great, too.
But I'm a cheapskate and the idea of paying Callcentric for 800- number calls just doesn't sit well, so I'd like to modify the digit map to peer to SIP Broker (**275) before sending out the toll-free digit strings. When I was using a regular old SIP, I used the dial plan below, but I have to admit to having a hard time understanding the multi-layer digit maps the OBI's use. Anyone know how to convert this to a digit map to accomplish that?
(*xx.|*xxx|*75xx|[3469]11|0|00|<:**275*>1800x.|<:**275*>1866x.|<:**275*>1877x.|<:**275*>1888x.|[2-9]xxxxxx|1xxx[2-9]xxxxxxS0|xxxxxxxxxxxx.|**275*x.)
RonR:
This will send your toll free calls though SP2 (Callcentric) via Sip Broker instead.
Service Providers -> ITSP Profile B -> General -> DigitMap:
(*123|**275*xx.|[2-9]11|<**275*>(18(00|88|77|66|55)xxxxxxx|<1>8(00|88|77|66|55)xxxxxxx)|
1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|<1aaa>[2-9]xxxxxx|011xx.|(Mipd)|[^*#]@@.'@'@@.)
where aaa is your local area code.
Gennady:
I have PSTN line in Canada and my VOIP provider located in Ukraine and mapped to SP2. I'm trying to setup the rule: prefix 8044 going to SP2 and 8044 substracted from #. Here is my settings:
Phone Port ->OutboundCallRoute:
{([1-9]x?*(Mpli)):pp},{(<#:>|911):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<8044:>(Msp2)):sp2},{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}
ITSP Profile B -> DigitMap:
(<8044:>xxxxxxx|xxxxxxx)
LINE Port-> DigitMap:
(xxxxxxxS4|1xxxxxxxxxx|xx.)
Works Ok, but it's a long delay before phone start ringing. I was following Ron's suggestions and changed Line Digimap to
[2-9]11|416xxxxxxx|905xxxxxxx|647xxxxxxx|289xxxxxxx|1xxxxxxxxxx|3xxxxxx|011xxxxxxxxxxxx)
After this change all calls started with 8044 are not going to SP2 at all. Any help?
RonR:
Leave the PHONE Port DigitMap and OutboundCallRoute, and the ITSP Profile B DigitMap at Default.
Assuming your PrimaryLine is PSTN Line, set:
Physical Interfaces -> LINE Port -> DigitMap:
([2-9]11S0|[2-9]xxxxxx|1xxxxxxxxxx|011xx.|<8044:**2>xxxxxxx)
Navigation
[0] Message Index
[#] Next page
[*] Previous page