setup 110 with dialing rules
wcnngt:
Here is what I like to do, can anyone tell me how to setup the dialing rules?
my obi110 is setup with gv as sip1 and callcentric as sip2.
if I dial international, use sip2 (callcentric)
if I dial US number, then if the number matches one of my three cell phone numbers, use PSTN port,
otherwise, use sip1 (GV)
The reason for this setup is that I connect my cell phone through bluetooth link to the PSTN port. And family plan allows unlimited talk between cell phones.
pc44:
Hi wcnngt,
Here we go... :-X
Set your Service Providers -> ITSP Profile A -> General -> DigitMap to the following:
(<**8>(CELL_PHONE_ONE|CELL_PHONE_TWO|CELL_PHONE_THREE)|<1ABC>[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|<**2>011xx.)
Replace CELL_PHONE_ONE, CELL_PHONE_TWO, and CELL_PHONE_THREE with the cell numbers you mentioned. Replace ABC with your area code. Make sure your Primary Line is SP1 (it should be by default, unless you changed it).
Test and report back with my failures :'(
pc44
wcnngt:
Thank you so much. I will try it out tomorrow. One more question, for the cell phone, can it fail back to sip1 if there is no dial tone on PSTN?
pc44:
Quote from: wcnngt on June 11, 2012, 05:53:25 am
Thank you so much. I will try it out tomorrow. One more question, for the cell phone, can it fail back to sip1 if there is no dial tone on PSTN?
I would first see if the above digit map works or not and take this one step at a time... so as not to confuse things. (I'm talking about getting myself confused ;D)
Right now, using the digit map above, you would want to keep Physical Interfaces -> PHONE Port -> PrimaryLine set to SP1.
But to answer your next question, if the PSTN is not available, there is an option for the OBI to use another available service. I'm not sure if the lack of a dial tone would be sufficient, but here is something you could try. This would change the default line for all outgoing calls. So, if you decide to go this route, I think you will need to re-work the digit map above.
Voice Services -> Gateways and Trunk Groups -> Trunk Group1 -> li,sp1
pc44
wcnngt:
I tried the first setup and it works perfectly. Thank you so much.
Now If I try to dial cellphone without a cellphone connected (no dial tone on PSTN), the call will fail. Would you let me know the setup for fail proof the PSTN line? Thanks.
Navigation
[0] Message Index
[#] Next page