setup 110 with dialing rules
wcnngt:
Dialing through cell phone works this time. But it won't fail over GV. It will give one waiting for connect tone, then silence for a few seconds, and beeping.
I think it is the xlink problem. Although it has no dial tone without a cellphone connected, obi sees it still as connected.
I think I will do without the cellphone specific connection. I learned a lot with your help. Here is the digitmap I come up myself:
(<1ABC>[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|<**2>011xx.)
and I will put it in Service Providers -> ITSP Profile A -> General -> DigitMap.
Am I right?
pc44:
Quote from: wcnngt on June 13, 2012, 06:07:37 am
Dialing through cell phone works this time. But it won't fail over GV. It will give one waiting for connect tone, then silence for a few seconds, and beeping.
I think it is the xlink problem. Although it has no dial tone without a cellphone connected, obi sees it still as connected.
I think I will do without the cellphone specific connection. I learned a lot with your help. Here is the digitmap I come up myself:
(<1ABC>[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|<**2>011xx.)
and I will put it in Service Providers -> ITSP Profile A -> General -> DigitMap.
Am I right?
Hi wcnngt,
If you are doing away with the specific cellphone rules, then yes, I believe your digit map will work! :) Just make sure your Physical Interfaces -> PHONE Port -> PrimaryLine is SP1 once again so that your U.S. calls default to your GV.
Here is a post that might apply to the OBI detecting the PSTN status: Call forward to mutiple numbers?
Sorry we could not get it working quite the way we hoped!
pc44
wcnngt:
I checked what signal xlink gives when no cell phones are connected, it gives out busy line signal. Do you think obi can detect it?
pc44:
Apart from trying each of the DetectOutboundConnectMethod options in the post referenced above, the only other thing that comes to my mind is the call forward on busy option. If your xlink is issuing a true busy signal to the OBI, then perhaps you could use one of the OBI's call forward on busy options to redirect the call to GV. Just a theory.
ianobi:
@ wcnngt - I'm about six weeks late with this idea, but here goes anyhow!
If you look in the advanced settings in the xlink, there is one called "toggle battery". Check this and then the xlink will remove the battery feed to the obi when no cell phones are connected. Then you could revisit the Trunk Group idea as I'm sure the Obi will see lack of battery as no service on li and move onto sp1.
Navigation
[0] Message Index
[#] Next page
[*] Previous page