Sending a fax through Obi202?
pc44:
QBZappy,
Great idea. As alluded to earlier, I do not currently have a VoIP provider with T.38 support but hope to have that capability during the next month approximately.
In the meantime, I set my Codec Profile B to disable all Codecs, with the exception of T.38. I tested this profile with GV on my SP4 (SP4 Service -> X_CodecProfile: B), and the call completed, albeit by kicking SP4 back down to G711U, (Call Status: tx=G711U; rx=G711U).
Perhaps the Codec Profile configurations do not apply to GV, because apparently even with the G711U Codec Disabled, the call is still placed using G711U. If this is the case, I shall have to wait until I have a T.38 VoIP provider at my disposal to further test.
Thank you for this input!
pc44
Ostracus:
Code:
Please note that the codec is limited to G711u only for all calls.
In reference to GV in the admin guide.
UserAsdf:
Am I the only person having problems with the Obi202 silencing the answering end almostly immediately after the answering fax machine begins sending fax tones?
QBZappy:
UserAsdf,
Forget about voipms. We've been there before. Voipms is useless for fax. Try forcing the T38 as I mentioned above and try again with CC.
UserAsdf:
I've already tried disabling all codecs except T.38 a few days ago. That resulted in an error message saying something about the service provider not supporting the call or something. I can't remember the exact error message. I can give it another try tomorrow for an exact error message. (Currently rushing out the door for festivities :))
I've been focusing on Callcentric since voip.ms doesn't advertise anything regarding fax capability. I did try voip.ms a few times out of curiosity. The same thing happens with both providers via my Obi202.
I've also submitted screenshots of my Obi configs to Callcentric, and they didn't find anything obvious to correct.
Both providers pass the answering fax tones perfectly (to my ears) when using softphones, so it's definitely an Obi issue.
I'm inclined to believe I have a defective unit, so I've already placed an order for a new one and I'll be sending this one back. If I find a solution before then, then I'll keep both. ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page