Sending a fax through Obi202?
DChappell:
I'm having this exact same issue with my 202, where the fax "handshake" is being cut off or "silenced" by the 202 a couple of seconds after it is initiated.
After reading through this thread I am trying to locate where I can uncheck the "T38Enable" setting but for the life of me cannot find it anywhere in my 202 expert setup. Could somebody point me in the right direction please?
Thanks!
ianobi:
DChappell,
Welcome to the forum.
Find your way to the Codec pages, best do Codec Profile A and Codec Profile B. T38 is right at the bottom of the page.
DChappell:
Quote from: ianobi on September 13, 2012, 07:41:22 am
DChappell,
Welcome to the forum.
Find your way to the Codec pages, best do Codec Profile A and Codec Profile B. T38 is right at the bottom of the page.
Thanks!! One problem... I do not have anything about T38 in ANY of my Codec Profile pages. :( Only codec's I've got are G711U / G711A / G729 / G726R32 / iLBC. Currently the only codec's I have enabled are the G711U & A.
Maybe I've got an older firmware? (jusst checked and I'm running the latest 3.0.0 build so that's not it)
ianobi:
That's odd! I have a OBi110 not a OBi202, so I can't check. I was looking at Codecs on page 147 of the OBiDeviceAdminGuide.pdf and there it is right at the bottom - T38Enable.
DChappell:
Interesting... Just looking at the admin guide and it has a LOT more codec's listed that what I have access to via my ObiTalk Expert Settings... Time to fire off a ticket to Obi.
Thanks!
Navigation
[0] Message Index
[#] Next page
[*] Previous page